RIDGID AC9944 Manuale dell'Operatore

1Your miter saw utility vehicle has been engineered and manufactured to our high standard for dependability, ease of operation, and operator safety. W

10ASSEMBLYWARNING: The saw mounting brackets are designed to fit snugly over the table edges with locking levers in the open position. With the

11 NOTE: Continue to hold the saw and bracket assembly with one hand until both levers are securely locked. Check position and adjust, if necessary,

12�To remove saw from workstand: Push locking lever release buttons and raise the locking levers to unlock the saw mounting brackets assembly.�� Gra

13DOBLEZ ABAJOFOLD DOWNSETUPSUJETE Y SOSTENGA EL MANGO DE APOYO FIRMEMENTE Y EN FORMA SEGURA AL DESPLEGAR O PLEGAR EL BANCOSERREZ BIEN ET TENEZ FERMEM

14OPERATIONWARNING:Do not allow familiarity with products to make you careless. Remember that a careless fraction of a second is sufficient to inflict

151520253035404510USING THE WORK SUPPORTSee Figure 20.Rest the workpiece on top of the work support to support the workpiece during cutting operations

16MAINTENANCEWARNING:When servicing use only identical RIDGID replacement parts. Use of any other parts may create a hazard or cause produ

17MAINTENANCEFig. 23WARNING: The saw mounting brackets are designed to fit snugly over the table edges with locking levers in the open position

18NOTES

19WARRANTYProof of purchase must be presented when requesting warranty service. Limited to RIDGID® hand held and stationary power tools purchas

2 Introduction ...

20Customer Service Information:For parts or service, contact your nearest RIDGID authorized service center. Be sure to provide all relevant informatio

3RULES FOR SAFE OPERATIONSafe operation of this accessory requires that you read and understand this operator’s manual, the operator’s manual for the

4Some of the following symbols may be used on this product. Please study them and learn their meaning. Proper interpretation of thes

5FEATURESFig. 1TOOLS NEEDEDThe following tools (not included) are needed for assembly:ADJUSTABLE WRENCH(S)WORKSUPPORTWORK STOPEXTENSIONARMQUICK RELEAS

6The following items are included with your miter saw workstand: Workstand Assembly Quick Release Saw Mounting Brackets (2) Work Supports (2)

7 Pull up on lock mechanism release lever and carefully raise wheel legs. Continue to raise wheel leg set until locked into position.U

8Fig. 6ASSEMBLYSECURING THE LIFT ASSIST HANDLESee Figures 5 - 6. Insert hex bolt into hole on each side of handle but do not insert through stand ta

9Fig. 10ASSEMBLYATTACHING THE TRANSPORT HANDLESee Figure 8. Align transport handle ends with holes in stand table end caps and insert. Place a spr